Ultimaker 2 Print Quality - Simplify3D Profile

Finally got my Ultimaker 2 Profile for Simplify3D working to a level that I feel is pretty decent.  This version of the #3DBenchy was done at 150 microns at a slightly faster speed (40mm/s) than the post that showed the results from the Wanhao.  Again, it may not be totally perfect but I am willing to call it close enough, especially given the speed difference...but only for this resolution.  I still want to see this model done at the high level of detail that the Ultimaker is capable of doing.

The same notes as to how I got here apply from the Wanhao post, other of course, than the fan as the UM2 comes with one.

Here is the Simplify3D profile (Version 2.2) and following are screen shots of the relevant parameter pages.  Please see this previous post for some commentary on these pages and their settings. 

Note that THIS IS A WORK IN PROGRESS!  I am still tuning this profile. It is worth a note to say that as you lower your layer height and slow down speed for quality you may need to raise the extrusion temperature.   I think this is especially true at the sub-100 micron resolution that the UM2 is capable of doing.