I had to do a reprint of one of the tank models using the 0.25mm nozzle with a layer height of 0.08mm. This is approaching, but not quite at, the best quality that my Ultimaker 2 can produce. I could have printed this model with a layer height of 0.06 and, while I do not have one, there is a 0.15mm nozzle for even finer tiny details. I printed at 25mm/sec so I could also have slowed down some. However...this print already was going to take over eight hours so I left it at pretty darn good ...
... EXCEPT ... for the quality issue that I have that left some gaps on the top fill. I can easily tune this out but it was too late for this print! Frustrating!
 |
| Just to be Clear on Size! |
Other posts in the "tank" series:
Second Order was for a Tank!Tanks, Tanks, and More Tanks!
Some More Tanks
Removing Support from a Tank Print
Tired of Tanks Yet?
Visual impact of Resolution (Layer Height) and Speed
No comments:
Post a Comment