Evolution of a Blog

This blog has evolved as I have as a maker. It starts at the beginning of my journey where I began to re-tread my tires in the useful lore of micro electronics and the open-source software that can drive them. While building solutions around micro-electronics are still an occasional topic my more recent focus has been on the 3D Printing side of making.

Friday, February 28, 2014

Calibration, calibration, calibration

equals iteration, iteration iteration.

The most extreme of the overhangs was the most challenging, and in fact, is still not perfect.  Interestingly the only way I was able to get it as far as it is gotten was to print it sideways and have another object printing above it so the fan plays on it more than if it were printed alone.

No comments:

Post a Comment