Evolution of a Blog

This blog has evolved as I have as a maker. It starts at the beginning of my journey where I began to re-tread my tires in the useful lore of micro electronics and the open-source software that can drive them. While building solutions around micro-electronics are still an occasional topic my more recent focus has been on the 3D Printing side of making.

Friday, February 5, 2016

Tale of Two Marvins

Someone had asked what settings I was using for ABS on my Ultimakers referring to problems they were having with printing the Marvin calibration object.  I had not printed a Marvin in a while so did the below as a test.   They are not perfect but they are pretty decent.  Left is ABS and right is PLA.  Both at 80 micron layer height.

Simplify 3D profiles used for the above: ABS PLA

No comments:

Post a Comment